Siemens PCS 7 - Solutions for Single Station Systems; OS Single Station System

3.2.5 Backing up SIMATIC Route Control data
3.2.5.1 Backing up configuration data
Data backup options
SIMATIC Route Control provides the following options for backing up and restoring project
data.
● You can back up the project data from SIMATIC Route Control with a PCS 7 project.
For additional information, refer to the "How to archive a project (Page 17)" section.
● You can generate an image of the partition on which the project database is located.
● You can export/import the partial routes of SIMATIC Route Control.
For additional information, refer to the "How to back up project data from SIMATIC Route
Control (Page 29)" section.
Additional information
● Manual
Process Control System PCS 7; SIMATIC Route Control
3.2.5.2 How to back up project data from SIMATIC Route Control
Introduction
This section describes the separate backup of partial routes from SIMATIC Route Control to
a file.
Note
You can back up the partial routes with the offline project data from SIMATIC Route Control.
The interface blocks are part of the PCS 7 project and are backed up during the archiving of
the PCS 7 project.
Preparing the database backups
Before performing a backup, you must always carry out the following steps in Route Control
engineering:
● Check the database consistency via the menu command Options > Check Consistency.
● Compress the database via the menu command Options > Compress Database.
Ensuring Availability
3.2 Data backup
Service support and diagnostics (V8.0)
Service Manual, 03/2012, A5E02779775-02 29