7.18.8.4 BT 200 bus test device
Overview
Note
The bus test device is not a software program – for this reason, the Call column is omitted.
Topic Details Information and Help
Bus line diagnostics Tests for :
● Line break
● Monitor breaks
● Line exchange A ←→ B
● Short circuit
● Number of terminating resistors inserted
● Reflection points (for example, for line breaks)
Device description
Test of PROFIBUS
interfaces
● RS 485 drivers
● Internal voltage supply at 5V
● RTS signal
Device description
Test of accessibility ... of stations Device description
Protocol functions Device description
7.18.8.5 SYSTEM Process Control Diagnostics (add-on product)
Introduction
Display of PROFIBUS diagnostic information on the operator station
Online help:
SYSTEM DIAGNOSTICS help
Overview
Topic Detailed information Called with Additional information
PROFIBUS DP – General Station failure
Display from HW Config
Picture in the OS See "Configuration"
below
PROFIBUS DP fault Fault indication with
detailed information
about cause of error
Picture in the OS See "Configuration"
below
From HW Config
Information
"Name and comments" Picture in the OS See "Configuration"
below
Configuration information Order number,
addresses, slot types
Picture in the OS See "Configuration"
below
Diagnostics in PCS 7
7.18 Diagnostic tools
Service support and diagnostics (V8.0)
Service Manual, 03/2012, A5E02779775-02 119
To Next Page
Loading...
