Siemens AG SPR8-125.831.01.02.02 POLYMOBIL Plus
05.05 CS PS 24
General 17
Page 17 of 40
Medical Solutions
The measuring method (differential measurement or direct measurement) and the mea-
suring device used (designation and serial number) are to be documented.
For repeated measurements, the measuring value is to be evaluated additionally.
NOTE
For evaluation, the value first measured and the values document-
ed during previous maintenance or safety tests are to be com-
pared with the measured values. A sudden increase of the
measured values, even if the limit value of 2.5 mA is not exceeded,
indicates errors in the primary circuit of the mains voltage supply
(insulation damages, damages due to dampness, faulty suppres-
sor element or similar).
In case of new determination, evaluation is not required.
The report “Device leakage current / report” is to be filed in the “Certificates” register in the
system folder.
NOTE
The report “Device leakage current / report” is filed in the “Certifi-
cates” register in the system folder.
NOTE
If documentation of device leakage current measurement is miss-
ing, a new report must be created.
A new report “Device leakage current / report” is included in the
startup instructions SPR8-125.034.02.02. Detach the report from
this instruction, complete it and file it in the “Certificates” register
in the system folder. For a first determination, the determined val-
ues are to be logged as values measured for the first time. Evalu-
ation is not required in this case.
To Next Page
Loading...
Need help?
General
