[sc_7SR5_EventLogDisplay, 1, --_--]
Figure 7-4 Event Log Display
Filtered Events from Front Fascia
Filtered events are available from the relay fascia display.
The filtered events can be configured in Reydisp Manager 2. To access the user should right click on Configu-
ration > Serial Comms & Events and select Configure Events to open the configuration events window.
Indications can then be selected. To show the desired events in the event log the user can click on the right
side boxes (Show on HMI).
The event text displayed in the event log can be edited in the Display Name window of the event filter config-
uration.
After completing any filtering and editoring required the file is saved as part of the device configuration and
will be sent when the configuration is sent to the device. After sending the configuration to the device,
selected events are shown in the front fascia HMI display event log list. This enables the user to determine
associated events displayed from the front fascia events (for example only faults).
[sc_7SR5_EventsConfiguration, 1, --_--]
Figure 7-5 Configuration of Event Logs
7.4.3
In Service Operation
7.4 Indications
Reyrolle 7SR5, Operating, Manual 103
C53000-B7040-C013-1, Edition 05.2021
To Next Page
Loading...
