Siemens Reyrolle 7SR5 - Unpacking, Repacking, Returning, and Storing

Unpacking, Repacking, Returning, and Storing
Unpacking a Device
i
i
NOTE
Devices are tested prior to delivery. The test certificate is a component of the devices.
•
Check the packaging for external transport damage. Damaged packaging may indicate that the devices
inside have also sustained damage.
•
Unpack devices carefully; do not use force.
•
Check the devices via a reception control to ensure they are in perfect mechanical condition.
•
Check the enclosed accessories against the delivery note to make sure everything is complete.
•
Keep the packaging in case the devices must be stored or transported elsewhere.
•
Return damaged devices to the manufacturer, stating the defect. Use the original packaging or transport
packaging where possible.
•
Check the wiring terminal connectors are all included.
•
Check the mounting fixings are included.
•
Check the screws are included – one packet per terminal block.
Repacking a Device
•
If you store devices after reception control, they must be packed in appropriate storage packaging.
•
If the device is to be transported, pack it in transport packaging.
•
Enclose the accessories supplied and the test certificate in the package with the device.
Returning a Device
•
Return devices to the manufacturer, stating the defect. Use the original packaging or transport packaging
where possible. Send damaged devices to the following address:
Siemens AG
EM DG PRO MF Rückwaren
Rohrdamm 7
13629 Berlin
Germany
•
Protect the optical interfaces on the communication modules and AFD when fitted against the ingress of
dust. Use, for example, the protective caps provided in the delivery condition.
Storing a Device
•
Only store devices on which you have carried out an incoming inspection, This action ensures that the
warranty remains valid. The incoming inspection is described in
1.2 Incoming Inspection.
•
Reyrolle devices must be stored in rooms, which are clean and dry. Devices must be stored at a tempera-
ture of -25 °C to +70 °C.
•
The relative humidity must be at a level where condensed water and ice are prevented from forming.
•
Siemens recommends that you observe a restricted storage temperature range of +10 °C to +35 °C, in
order to prevent the electrolytic capacitors used in the power supply from ageing prematurely.
1.1
First Steps
1.1 Unpacking, Repacking, Returning, and Storing
12 Reyrolle 7SR5, Operating, Manual
C53000-B7040-C013-1, Edition 05.2021