Displays for Indication and Control
Displays
Displays for indication and control offer you the possibility of quickly obtaining an overview of important oper-
ating modes. You can configure a total of up to 5 different display screens in Reydisp Manager 2 using the
display editor. The following contents are available here:
•
Dynamically updated measured values
•
Status of indications
•
Switch positions of switching objects
•
Static or dynamic texts
•
Graphical and controllable elements
•
Add access control via Setting and User IDs
•
Resetting of password is a fascia operation
NOTE
The displays and controls on the HMI screen are created in Reydisp Manager 2.
The LCD contrast can be adjusted by pressing the Enter and Cancel pushbuttons together and then using
the â–² or â–¼ keys to increase or decrease the contrast.
The backlight brightness adjusted by pressing the Enter and Cancel pushbuttons together, then pressing
the right arrow â–¶ pushbutton to select brightness and then using the â–² or â–¼ keys to increase or decrease the
level.
To conserve power the display backlighting is extinguished when no buttons are pressed for a user defined
period. The Backlight Timer setting within the Configuration > Device menu allows the timeout to
be adjusted from 1 to 60 minutes and Off (backlight permanently on).
Default Displays
The Device Not Configured message will flash up on the LCD after a short duration if the user has not
changed any parameter in the device (see
Figure 4-17). The display of the message cannot be disabled. The
action of changing any parameter or user configuration will automatically disable this alert message.
4.3
Using the Device Fascia
4.3 Displays for Indication and Control
Reyrolle 7SR5, Operating, Manual 47
C53000-B7040-C013-1, Edition 05.2021
To Next Page
Loading...
