Reading Indications from the PC with Reydisp Manager 2
To read the indications with Reydisp Manager 2 your PC must be connected via the USB user interface of the
on-site operation panel or via an Ethernet interface of the device. You can establish a direct connection to
your PC via the Ethernet interfaces. It is also possible to access all connected 7SR5 devices via a data network
from your Reydisp Manager 2 PC.
After clicking Get Device Data on the Tasks screen or alternatively Get buttons on the right hand side, the
device data can be retrieved from the device.
A connection window is provided to select between the default USB connection method or connecting via the
rear Ethernet port using the IP address of the device. Select the connection type to the device and click the
Next button to start getting device data read from the device.
[sc_7SR5_GetDeviceDataWindow, 1, --_--]
Figure 7-6 Get Device Data
Once complete, available data files will be stored under the Device Data tab that are read from the device. All
entries are archived and can be used with further applications.
To open data content the user can select and double click on the available Event log from the Device Data
window.
The Event Log Viewer window opens and any time tagging of any change of state (Event) in the relay can be
seen. As an event occurs, the actual event condition is logged as a record along with a time and date stamp to
a resolution of 1 millisecond.
When a starter picks-up (raised) and sometime later drops-off (cleared). In summary, a one stage event is
Raised only, a two stage event may be Raised or Cleared.
7.4.4
In Service Operation
7.4 Indications
104 Reyrolle 7SR5, Operating, Manual
C53000-B7040-C013-1, Edition 05.2021
To Next Page
Loading...
