Reading Instrument Values from Reydisp Manager 2
The Relay Instrument Monitor tool displays a real time list of instruments from the device. Real time analogue
values measurement requires the device to be connected to a PC from a USB or rear ethernet port to be data
transferred to a PC online.
If there is a communication connection to systems control, measured values that the operational crew can
verify are also transmitted here by rear ethernet communication.
The device is able to indicate the measurand values from Reydisp Manager 2 with connection by a COM-2
front USB port with the IP address 192.168.2.1, or user configured IP address from rear ethernet ports (Elec-
trical or LC optical).
[sc_7SR5_InstrumentMonitor, 1, --_--]
Figure 7-12 Opening the Relay Monitor Tool
Click on the Connect by USB button to connect through a USB front port or type a user defined IP address to
connect via a rear ethernet port.
Click the Connect button to open the Instruments window.
7.5.3
In Service Operation
7.5 Instruments and Meters
110 Reyrolle 7SR5, Operating, Manual
C53000-B7040-C013-1, Edition 05.2021
To Next Page
Loading...
