[sc_7SR5_DeviceFaultDataMenu, 1, --_--]
Figure 7-8 Fault Data
After a fault, the most important data of the last fault can be displayed automatically on the device display
with operational fault measures (Trip Alert must be enabled from Device settings in the Configuration menu).
NOTE
LEDs will remain illuminated when viewing other screens if the fault screen has not been acknowledged.
These displays remain stored in the device until manual acknowledgment or release by LED reset.
In Service Operation
7.4 Indications
106 Reyrolle 7SR5, Operating, Manual
C53000-B7040-C013-1, Edition 05.2021
To Next Page
Loading...
