The Output Matrix Test allows the user to test Binary Outputs. Before performing this test, signals must be
mapped in the Binary Outputs > Output Matrix from the Settings > Configuration menu
The Settings > Configuration > Maintenance > Output Matrix Test menu displays the functions that are
assigned to any binary output.
In the Output Matrix Test menu, view the signals with the down arrow key. Press the Enter button to perform
a test in this signal then, after a confirmation page, choose Yes with the up or down key and the press Enter.
The configured binary output will close.
[sc_7SR5_DeviceOutputMatrixTestCompleted, 1, --_--]
Figure 4-24 Output Matrix Test Completed
Using the Device Fascia
4.7 Display of Routings and Status
58 Reyrolle 7SR5, Operating, Manual
C53000-B7040-C013-1, Edition 05.2021
To Next Page
Loading...
