[sc_7SR5_ReydispManager2ConnectByUSB, 1, --_--]
Figure 5-11 Send Device Configuration Window
Connect by USB
The 7SR5 device provides one front USB communication interface (Com2) on the fascia to connect to every
modern PC. Sending configuration for the first time must be done via a USB port. Once the conventional USB
cable connected to a relay, proceed with Connect by USB in communication settings.
[dw_7SR5_communication_to_front_USB_port, 1, en_US]
Figure 5-12 Front USB Connection
The front USB port for local connection (Standard) with a cover provides environmental protection.
The device functions can be set on a PC using Reydisp Manager 2 software via the relay USB port by a standard
USB cable.
Using Reydisp Manager 2
5.3 Transmitting the Configuration to a 7SR5 Device for the First Time
Reyrolle 7SR5, Operating, Manual 69
C53000-B7040-C013-1, Edition 05.2021
To Next Page
Loading...
