Siemens RUGGEDCOM RSG2488 User Manual

Chapter 2
Installing the Device
RUGGEDCOM RUGGEDCOM RSG2488
Installation Guide
10 Installing the GPS Antenna (If Required)
2
1
1
Figure 6: Panel Mounting
1. Screw 2. Panel/DIN Rail Adaptor
2. Install the supplied screws to secure the adapters to the panel.
Section 2.2
Installing the GPS Antenna (If Required)
For increased signal coverage and improved performance, the GPS antenna is intended to be installed in
a remote location separate from the RSG2488. The signals received from the GPS satellite network are at
a frequency of 1575.42 MHz. The GPS antenna must therefore have a clear view of the sky to receive the
low power signals and track the maximum number of satellites. Structures, such as rooftops, that are clear of
obstructions and have a clear view of the horizon are ideal.
IMPORTANT!
A Radio Frequency (RF) site survey is recommended prior to any installation to help determine the
best location for the GPS antenna. For assistance, contact a Siemens Sales representative.
NOTE
Although it is impossible to protect the antenna from a direct lightning strike, the antenna and
connected components can be protected from secondary effects through site selection and by
installing protection devices.

Siemens RUGGEDCOM RSG2488 Specifications

General

Brand	Siemens
Model	RUGGEDCOM RSG2488
Category	Switch
Language	English