Siemens S7-1500 - Page 60

Technical specifications
6.7 Technical specifications for terminal modules
SIMATIC TOP connect for S7-1500 and ET200MP
60 Manual,
Table 6- 11 Technical specifications for terminal module TPS with LED
Terminal modules TPS (witch), 3-wire initiators with LED, incl. switch in the signal path
6ES7924-0CH20-0Bx0
Type of supply voltage
DC
Operating voltage max. 24 V
Max. permissible continuous current per signal
1 A
Max. permissible total current (power supply)
4 A / byte
Switch
Type
DIP slide switch
Activation during operation Activation during operation permitted,
Max. switching capacity 10VA,
ON = "top" position, set to "ON"
General data
Connection to SIMATIC fitted for
16-pin IDC connector with fitted strain relief
Operating temperature
0 to + 60° C
Mounting position
Any
Clearances and creepage distances IEC 60664-1, IEC61131-2,
CSA C22.2 No 142 UL 508, VDE 0160,
Overvoltage category II,
pollution degree 2
Dimensions (W x H x D) in mm
For 3-wire initiators with disconnector 6ES7924-
0CH20-0Bx0
Approx. 57 x 76 x 60
Table 6- 12 Technical specifications for terminal module TP2 without LED
Terminal modules TP2, 2 A modules without LED
6ES7924-0BB20-0Ax0
Type of supply voltage
DC
Operating voltage
max. 50 V
Max. permissible continuous current per signal 2 A
Connection to SIMATIC fitted for
16-pin IDC connector with fitted strain relief
Operating temperature
0 to + 60° C
Mounting position
Any
Clearances and creepage distances IEC 60664-1, IEC61131-2,
CSA C22.2 No 142 UL 508, VDE 0160,
Overvoltage category II,
pollution degree 2
Dimensions (W x H x D) in mm
For 2 A modules 6ES7924-0BB20-0Ax0
Approx. 57 x 76 x 60