Siemens S7-1500 - Page 63

Technical specifications
6.7 Technical specifications for terminal modules
SIMATIC TOP connect for S7-1500 and ET200MP
Manual,
63
Table 6- 15 Technical specifications for terminal module TPRo
Terminal module TPRo with relays for outputs
6ES7924-0BD20-0Bx0
Energizing side
Operating voltage for coil 24 V DC 19 - 28.8 V
Input circuit Reverse polarity protection and freewheeling
diodes
Contact side
Number of relay outputs
8 NO contacts
Contact design
Single contact, 1 NO contact
Switching capacity (resistive load)
max. 4 A / 250 V AC
max. 3 A / 30 V DC
max. 0.6 A / 48 V DC
max. 0.4 A / 60 V DC
Recommended minimum load ≥ 1 mA
Switching frequency
6 cycles/minute
Service life
Mechanical
3 x 10
6
switching cycles
Electrical 5 x 10
4
switching cycles at 230 V AC/4 A/ cos φ =
1, 6 x per minute
Inductive loads To protect the relay contacts, inductive loads
must be dampened externally with an effective
protective circuit. No measures are provided for
this in the TPR.
Connection to SIMATIC fitted for
16-pin IDC connector with fitted strain relief
Operating temperate
0 … +60° C
Mounting position Any
Clearances and creepage distances IEC 60664-1, IEC61131-2,
CSA C22.2 No 142 UL 508, VDE 0160,
overvoltage category II,
pollution degree 2
Dimensions (W x H x D) in mm
6ES7924-0BG20-0Bx0 Approx. 100 x 76 x 60