Siemens S7-200 - Page 122

Operating Your Text Display (TD) Device
5.6 Performing Typical or Routine Operator Tasks
Text Display (TD) User Manual
122 System Manual, 08/2008, A5E00765548-03
If the TD device was not configured to allow changes to the time or if the S7-200 CPU does
not support the TOD clock, the Set Time and Date command does not appear on the
Operator Menu.
After you select the Set Time command, the TD device reads the current date and time from
the S7-200 CPU.
The Time and Date screen displays the following information:
● Date: day-month-year (for Chinese, the date is displayed as year-month-day)
● Time
● Day of the week
'LVSOD\$ODUPV
2SHUDWRU0HQX
'LDJQRVWLF0HQX
5HOHDVH3DVVZRUG
&386WDWXV
6HW7LPHDQG'DWH
6HW/DQJXDJH
Figure 5-12 Setting the Time and Date on the TD 200, TD200C, and TD400C
Use the UP or DOWN arrow buttons to change the values in the fields.
Use the ENTER to move to the next field. (For a TD 100C, TD 200C, and TD400C, you can
also use the RIGHT arrow. For a TD 200, you can use the SHIFT+DOWN arrow.)
Use the ESC to move back to the first field. (For a TD 100C, TD 200C, and TD400C, you
can also use the LEFT arrow. For a TD 200, you can use the SHIFT+UP arrow.)
'LVSOD\$ODUPV
&386WDWXV
6HW7LPH
5HOHDVH3DVVZRUG
Figure 5-13 Setting the Time and Date on the TD 100C
Pressing ENTER when the cursor is located on the last field of the Time and Date screen
writes the new time and date values to the S7-200 CPU and returns to the Operator Menu.
Pressing ESC when the cursor is located on the first field of the Time and Date screen
returns to the Operator Menu.