Siemens S7-300 - Lightning and Surge Voltage Protection

$SSHQGL[
S7-300 Automation System, Hardware and Installation: CPU 312IFM - 318-2 DP
12-16 A5E00203919-01
 2XWGRRUFDEOHURXWLQJ
5XOHVIRU(0&FRPSDWLEOHFDEOHURXWLQJ
The same EMC compatibility rules apply both for indoor and outdoor routing of
cables. The following also applies:
• Running cables on metal cable trays.
• Electrical connection of the joints of cable trays/ducts.
• Ground the cable carriers.
• If necessary, provide adequate equipotential bonding between connected
devices.
• Take the necessary (internal and external) lightning protection and grounding
measures in as far as they are applicable to your particular application.
5XOHVIRUOLJKWQLQJSURWHFWLRQRXWVLGHEXLOGLQJV
Run your cables either:
• in metal conduits grounded at both ends, or
• in concrete cable ducts with continuous end-to-end armoring.
2YHUYROWDJHSURWHFWLRQHTXLSPHQW
An individual appraisal of the entire plant is necessary before any lightning
protection measures are taken.
$GGLWLRQDOLQIRUPDWLRQRQOLJKWQLQJSURWHFWLRQ
can be found in the Lightning and surge voltage protection section.