Siemens S7-300 - Page 84

,QVWDOODWLRQ
S7-300 Automation System, Hardware and Installation: CPU 312IFM - 318-2 DP
6-8 A5E00203919-01
,QVWDOODWLRQVWHSV
The steps for installing the modules are described below.
1. Plug the bus connectors into the CPU and
signal/function/communication/interface
modules.
One bus connector is included per
module, but not for the CPU.
• Always start at the CPU when you plug
in the bus connectors. Here, take the
bus connector of the "last" module in
the row.
• Insert the bus connectors into the
other modules.
The "last" module is not equipped with
a bus connector.
CPU
2. Add all modules in their specified
sequence to the rail , slide them up to
the module on the left ), then swing
them down .
CPU
2
1
3
3. Manually tighten the module screws.
CPU
,QVHUWWKHNH\&38VZLWKNH\VZLWFKRQO\
Once you have installed the modules, you can insert the key into the CPU mode
selector switch.