Connecting SCALANCE S615 to the WAN
1.5 Changing the IP settings of the S615
SCALANCE S615 Getting Started
Getting Started, 03/2015, C79000-G8900-C390-01
17
1. Click on "Layer 3" > "Subnet" in the navigation area and on the "Configuration" tab in the
content area.
2. Enter the IP address for vlan1 according to the table "Settings used (Page 9)".
3. Click "Set Values".
The IP address is adjusted automatically in the address bar of the Web browser. The
Web browser on the Admin PC can no longer access Web Based Management because
its IP settings no longer match.
4. On the Admin PC, open the Control Panel with the menu command "Start" > "Control
Panel".
5. Click "Network and Sharing Center" and select the "Change Adapter Settings" option in
the navigation menu on the left.
6. In the "Local Area Connection Properties" dialog, enable the "Internet Protocol Version 4
(TCP/IPv4)" check box.
To Next Page
Loading...
