Syntax
Call the command without parameters:
wlan ipcf-ht
Result
The iPCF mode is enabled.
Further notes
You disable the iPCF-HT mode with the no wlan ipcf-ht command.
You display the setting with the show wlan ipcf-ht command.
5.5.2.2 no wlan ipcf-ht
Note
This command is only available with the following KEY-PLUG:
● W780 iFeatures (MLFB 6GK5 907-8PA00)
Description
With this command, you disable the iPCF-HT mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameters:
no wlan ipcf-ht
Result
The iPCF mode is disabled.
Further notes
You enable the iPCF mode with the wlan ipcf-ht command.
You display the setting with the show wlan ipcf-ht command.
Functions specific to SCALANCE
5.5 iPCF-HT
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 133
To Next Page
Loading...
