4.1.10.10 system contact
Description
With this command, you enter contact information for the system.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
system contact <contact info>
The parameter has the following meaning:
Parameter Description Range of values / note
contact info Input box for contact information max. 255 characters
Result
The contact information is created in the system.
4.1.10.11 system location
Description
With this command, you enter the location information for the system.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
system location <location name>
Configuration
4.1 System
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 73
To Next Page
Loading...
