See also
show wlan security ap-radius-authenticator (Access Point) (Page 496)
11.3.2.6 wlan security ap-radius-authenticator primary
Description
With this command, you configure the RADIUS server as primary server.
Note
This command is available only in access point mode.
Requirement
You are in the WLAN Configuration mode and the "wlan security ap-radius-authenticator
address" is configured.
The command prompt is as follows:
cli (config-wlan)#
Syntax
Call up the command with the following parameters:
wlan security ap-radius-authenticator primary <index (1-2)>
The parameter has the following meaning:
Parameter Description Range of values / note
index Index of the RADIUS server 1...2
Result
The RADIUS server is configured as primary server.
Further notes
You disable the setting with the no wlan security ap-radius-authenticator
primary command.
You display the setting with the show wlan security ap-radius-authenticator
command.
Security and authentication
11.3 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
504 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
