Syntax
Call the command without parameters:
spanning-tree mst configuration
Result
You are now in the MSTP configuration mode.
The command prompt is as follows:
cli(config-mst)#
Further notes
You exit the MSTP configuration mode with the end or exit command.
7.3.3.10 spanning-tree mst instance-id root
Description
With this command you specify whether the device is a root bridge (primary) or a substitute
root bridge (secondary).
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
spanning-tree mst{instance-id<instance-id(1-64)>}root{primary|
secondary}
The parameters have the following meaning:
Parameter Description Range of values / note
instance-
id
Keyword for the instance -
instance-
id
Number of the instance 1 ... 64
Network structures
7.3 Spanning Tree
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
316 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
