The parameters have the following meaning:
Parameter Description Range of values / note
mst Keyword for a Multiple Spanning Tree
instance
-
instance-id Number of the instance 1 ... 64
Result
The priority of the device is reset to the default value.
Further notes
You configure the setting with the spanning-tree priority command.
You display this setting and other information with the commands that start with show
spanning-tree ....
7.3.3.16 Time settings for the Spanning Tree protocol
spanning-tree (time settings)
Description
With this command, you configure the various time settings of the spanning tree function:
● With the forward-time option, you configure the time after which a port changes its
spanning tree status from "Blocking" to "Forwarding".
● With the hello-time option, you configure the time after which the bridge sends its
configuration frames (BPDUs).
● With the max-age option, you configure the time after which the information of the BPDUs
becomes invalid.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
spanning-tree{forward-time<seconds(4-30)>|hello-time<seconds(1-2)>|
max-age<seconds(6-40)>}
Network structures
7.3 Spanning Tree
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 321
To Next Page
Loading...
