Result
The RADIUS server is enabled.
Further notes
You display the setting with the show wlan security ap-radius-authenticator
command.
See also
show wlan security ap-radius-authenticator (Access Point) (Page 496)
11.3.2.4 wlan security ap-radius-authenticator max-retransmit
Description
With this command, you configure maximum number of attempts to establish a connection.
Note
This command is available only in access point mode.
Requirement
You are in the WLAN Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-wlan)#
Syntax
Call up the command with the following parameters:
wlan security ap-radius-authenticator max-retransmit <index (1-2)>
<1-5>
The parameters have the following meaning:
Parameter Description Range of values / note
index Index of the RADIUS server 1...2
1-5 Number of connection attempts 1...5
Result
The maximum number of attempts to establish a connection is configured.
Security and authentication
11.3 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
502 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
