Requirement
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call up the command with the following parameters:
sender mail-address <mail-address>
The parameter has the following meaning:
Parameter Description Range of values / note
mail-address Email name of the sender max. 100 characters
Result
The e-mail name of the sender is configured.
Further notes
You reset the e-mail name of the sender with the no sender mail-address.
You display the setting with the show events sender email command.
8.7.2.4 no sender mail-address
Description
With this command, you reset the e-mail name of the sender.
Requirement
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call the command without parameters:
no sender mail-address
Result
The e-mail name of the sender is reset.
Network protocols
8.7 SMTP client
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
440 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
