Siemens SCALANCE W788-1PRO - Page 124

Configuration Using Web Based Management and the Command Line Interface
Syntax of the Command Line Interface
CLI\SYSTEM\SNMP>
Description Comment Command
snmp [E|D]
Pv1, v2c, v3 and
Enables / disables SNMP.
Enables / disables
SNM
Traps.
snmpv1 [E|D]
Enables / disables SNMPv1/v2c.
Enables / disables
SNMPv1, v2c and traps.
snmpv3 [E|
Enables / di 3.
The spe of
D]
sables SNMPv
cial features
SNMPv3 undertake effect
after you disable
SNMPv1. Enabling
SNMPv3 does not
automatically disable
SNMPv1.
snmpro [E|D]
Enables / disables SNMPv1/v2c
read only.
getcomm
[Read community string]
3
characters.
Specifies the Read community
string, maximum length 6
The default is public.
setcomm
[Write community string]
Specifies the Write community
string, maximum length 63
characters.
The default is private.
traps [E|D]
Enables / disables SNMPv1 traps.
also
Traps are then enabled, if
SNMP v1, v2c is
enabled.
Operating Instructions SCALANCE W78x
124
C79000-G8976-C184-07