Configuration Using Web Based Management and the Command Line Interface
C79000-G8976-C184-07
126
CLI\SYSTE
scription Comment
M\SNMP\USER>
Command De
add <user n
[NONE|MD
[authentica
[Encryption ]
group, the algorithm must be
specified as a parameter (MD5 or
must be specified as a parameter.
entication
n
be a maximum of 63
characters long.
ame> <group name>
Assigns an SNMPv3 user to a
group.
The auth
password an
5|SHA]
tion ID]
If authentication is necessary for the
d the
encryption password ca
ID
SHA).
If encryption is necessary for the
group, the encryption password
edit <index
<group n
[NONE|M
[authentica
[Encryption ID]
>
ame>
D5|SHA]
tion ID]
Changes the group assignment, the
authentication algorithm, and the
encryption password of the SNMPv3
user.
delete <Index>
Deletes an SNMPv3 user from the
list at the point identified by the
index.
clearall
Deletes all SNMPv3 users.
CLI\SYSTEM\SNMP\TRAP>
Command Description Comment
traps [E|D]
Traps are then enabled, if
SNMP v1, v2c is also
enabled.
Enables / disables SNMP traps.
settrap <entry>
Specifies the IP addre
recipient entry (entry
<IP address>
<E|D>
ss of the trap
between 1 and
10) and enables / disables the
sending of traps to this recipient.
Operating Instructions SCALANCE W78x
To Next Page
Loading...
