Siemens SCALANCE X-400

Configuration / project engineering
6.7 Show Location
SCALANCE X-400
132 Operating Instructions, 06/2015, C79000-G8976-C186-12
6.7
Show Location
Localizing an IE Switches X-400
To identify an IE Switch X-400 locally and with certainty, you can use the "show location"
function on a programming device to select the node over the network and make it flash.
This can be used, for example, when assigning addresses to make sure that the correct
node receives the address. All port LEDs of the addressed node flash green at 2 Hz.
With the PST Tool V3.0, you can trigger this function with "Module \ Ring".