Siemens SIDOOR ATD401W - Commissioning the control unit on the fieldbus

Commissioning the control unit on PROFIBUS
We recommend the following initial commissioning procedure for a control unit as DP slave on
PROFIBUS DP:
Table 10-2 Procedure for commissioning the control unit as a DP slave on PROFIBUS DP
Step Procedure See...
1 Commission the control unit without a 󹪝eldbus connec‐
tion as described in the previous sections.
Sections Preparing the control
unit (Page 295) to Connecting
digital inputs (Page 299)
2 Con󹪝gure the DP master (including PROFIBUS address) Documentation of the DP mas‐
ter
3 Switch on supply voltage for DP master Documentation of the DP mas‐
ter
4 Switch on supply voltage for control unit (DP slave) Connecting the power supply
to the network and executing
a learn run (Page 298) section
5 Load the con󹪝guration in the DP master Online help of the con󹪝gura‐
tion tool, e.g. STEP 7
6 Switch DP master to RUN mode Documentation of the DP mas‐
ter
7 Controlling LEDs on the control unit Final settings and checks
(Page 301) section
Commissioning the control unit on PROFINET
We recommend the following initial commissioning procedure for a control unit as IO device on
PROFINET IO:
Table 10-3 Procedure for commissioning the control unit as an IO device on PROFINET IO
Step Procedure See...
1 Commission the control unit without a 󹪝eldbus connec‐
tion as described in the previous sections.
Sections Preparing the control
unit (Page 295) to Connecting
digital inputs (Page 299)
2 Con󹪝guring an IO controller Documentation of the IO con‐
troller
3 Switch on the supply voltage for IO controller Documentation of the IO con‐
troller
4 Switch on supply voltage for control unit (IO device) Connecting the power supply
to the network and executing
a learn run (Page 298) section
5 Load the con󹪝guration into the I/O controller Online help of the con󹪝gura‐
tion tool, e.g. STEP 7
6 Switch I/O controller to RUN mode Documentation of the IO con‐
troller
7 Controlling LEDs on the control unit Final settings and checks
(Page 301) section
Connecting and commissioning
10.6 Commissioning the control unit on the 󹪝eldbus
ATD4xxW for industrial applications
300 System Manual, 06/2022, A5E51901827B AA