Siemens SIMATIC 6DL1 136-6AA00-0PH1 - Page 66

Diagnostic interrupt Error code E󹪜ective range
of diagnostic in‐
terrupt
Con󹪝gurable
Internal supply voltage fault 104
H
F-module No
Invalid/inconsistent 󹪝rmware present 11B
H
F-module No
Redundancy partner has di󹪜erent hardware/󹪝rmware version 120
H
F-module No
IO redundancy warning 121
H
F-module No
Diagnostic queue over󹪞ow 13E
H
F-module No
Invalid terminal block 152
H
F-module No
Carrier module or memory in carrier module is defective 154
H
F-module No
Terminal block (TB) or memory in terminal block is defective 155
H
F-module No
Overload or internal sensor supply short-circuit to ground 307
H
Channel No
F-address memory not accessible 30D
H
F-module No
No valid F-address available 30E
H
F-module No
Undertemperature 312
H
F-module No
Internal discrepancy failure 315
H
Channel No
Supply voltage too high 321
H
F-module No
Supply voltage too low 322
H
F-module No
Safety-related HART shuto󹪜 defective 32A
H
F-module No
ADC error 331
H
F-module No
Error in the test circuit 332
H
F-module No
Maintenance messages
The I/O module generates a maintenance message for the following events:
• Redundancy partner has di󹪜erent hardware/󹪝rmware version
• IO redundancy warning
• Carrier module or memory in carrier module is defective
• Terminal block (TB) or memory in terminal block is defective
• Internal temperature limit reached
• Internal malfunction of HART communication detected
• In addition, all HART diagnostics are reported as maintenance messages.
You can 󹪝nd more information on this in the section "Maintenance events (Page 72)".
Displays, alarms and messages
7.3 Interrupts
F-AI 8xI 2-/4-wire HART HA
66 Equipment Manual, 09/2021, A5E50557845-AA