Siemens SIMATIC 6DL1 136-6AA00-0PH1 - Application Case 1: Sil3;Cat.3;Pld, 2-Wire Transmitter, 1 Oo1

6.2 Application case 1: SIL3/Cat.3/PLd, 2-wire transmitter, 1oo1
De󹪝nition
In the following, you can 󹪝nd the wiring diagram and the con󹪝guration of the I/O module F-AI
8xI 2-/4-wire HART HA for application case 1:
• SIL3/Cat.3/PLd
• 1oo1 evaluation
• 2-wire transmitter
You can 󹪝nd possible diagnostic messages, their causes and remedies in the "Diagnostic
messages" section.
Wiring
You perform the wiring on the appropriate terminal block. You can 󹪝nd additional information
on this in the section "Terminal assignment (Page 17)".
Sensor supply
The sensor supply is internal for a 2-wire transmitter.
The sensor supply UVn is provided by the F-module for 8 channels.
Wiring scheme
XJSFUSBOTNJUUFS
&YUFSOBMXJSFKVNQFS
SFRVJSFE
*O
67O
*O
.O
.
-
'"*Y*XJSF)"35)"
%-""1)
WARNING
Requirement for sensor
To achieve SIL3/Cat.3/PLd using this wiring, you must use a quali󹪝ed sensor.
(FAIW-004)
Applications of the F-I/O module
6.2 Application case 1: SIL3/Cat.3/PLd, 2-wire transmitter, 1oo1
F-AI 8xI 2-/4-wire HART HA
40 Equipment Manual, 09/2021, A5E50557845-AA