Siemens SIMATIC 6DL1 136-6AA00-0PH1 - HART Configuration Tool

Con󹪝guration
You con󹪝gure the individual channels with respect to the actual analog value output and the use
of the HART variables in the input address space of the module.
You can con󹪝gure one 󹪝eld device per channel. The con󹪝guration/parameter assignment of the
connected 󹪝eld device is then carried out from this con󹪝gured 󹪝eld device using PDM or the EDD
for the ET 200SP HA.
Re-parameterization of the 󹪝eld devices
The I/O module generally accepts triggered recon󹪝gurations for 󹪝eld devices. Access rights can
only be allocated in the parameter assignment tool.
To reassign parameters of the 󹪝eld devices connected to the I/O module, proceed as follows:
1. You start the re-parameterization of a 󹪝eld device using a HART command that you enter
using the SIMATIC PDM parameter assignment tool.
2. After you complete re-parameterization of a HART 󹪝eld device, the corresponding bit is set in
the HART device status of the connected 󹪝eld device (in the 2nd status byte).
3. The re-parameterization of the 󹪝eld device causes the analog module to issue a maintenance
message "Con󹪝guration changed", if this is enabled. This maintenance message should be
regarded as a notice and not an error. It is automatically deleted again by the I/O module after
approximately 1 minute.
If enabled, a maintenance message can also be triggered by a new parameter assignment with
the handheld device.
WARNING
Impact of a connected HART handheld
Note that the "O󹪜" setting of the "HART gate" parameter is bridged by a connected HART
handheld.
FAIW-020
8.2.2 HART con󹪝guration tool
De󹪝nition
The HART parameters can be set either using an external hand-held device (HART Handheld) or
a HART con󹪝guration tool (PDM). Both assume the function of a "client".
The parameter assignment tool a󹪜ects the entire I/O module; the HART handheld is connected
in parallel to the 󹪝eld device.
HART function
8.2 HART system connection
F-AI 8xI 2-/4-wire HART HA
80 Equipment Manual, 09/2021, A5E50557845-AA