Siemens SIMATIC ET 200AL - Pin Assignments (DIQ MIX Mode); DIQ MIX Mode Pinout

Configuration modes for digital inputs/outputs
3.2 Wiring
Digital input/Digital output module DIQ 16x24VDC/0.5A 8xM12 (6ES7143-5AH00-0BA0)
Manual, 03/2019, A5E38688112-AC
19
Table 3- 6 Pin assignment for digital inputs/digital outputs
Pin
Assignment
Front view of the sockets
X14 to X17 sockets for digital inputs / outputs
X14, X16
X15, X17
1 24 V encoder supply 2U
S
(derived from 2L+ switched)
2 Output signal DQ
9
: Connector X14
Output signal DQ
11
: Connector X15
Output signal DQ
13
: Connector X16
Output signal DQ
15
: Connector X17
3 Ground 2M
4 Output signal DQ
8
: Connector X14
Output signal DQ
10
: Connector X15
Output signal DQ
12
: Connector X16
Output signal DQ
14
: Connector X17
5
Functional earth FE
Pin assignment of the sockets for digital inputs/digital outputs in the configuration mode DIQ MIX
The tables below show the pin assignments of the 8 sockets for connection of the digital
inputs/digital outputs in the configuration mode DIQ MIX.
In this configuration mode, socket pin 2 is always permanently assigned to input signals, pin
4 is always permanently assigned to output signals.
Table 3- 7 Pin assignment for digital inputs/digital outputs
Pin
Assignment
Front view of the sockets
X10 to X13 sockets for digital inputs / outputs
X10, X12
X11, X13
1 24 V encoder supply 1U
S
(derived from 1L+ non-switched)
2 Input signal DI
1
: Connector X10
Input signal DI
3
: Connector X11
Input signal DI
5
: Connector X12
Input signal DI
7
: Connector X13
3
Ground 1M
4 Output signal DQ
0
: Connector X10
Output signal DQ
2
: Connector X11
Output signal DQ
4
: Connector X12
Output signal DQ
6
: Connector X13
5
Functional earth FE