Siemens SIMATIC ET 200AL - Module Characteristics and Conditions; Interrupts, Diagnostics, Ambient Conditions, and Dimensions

Technical specifications
Digital input/Digital output module DIQ 16x24VDC/0.5A 8xM12 (6ES7143-5AH00-0BA0)
Manual, 03/2019, A5E38688112-AC
79
Article number
6ES7143-5AH00-0BA0
Interrupts/diagnostics/status information
Substitute values connectable
Yes; channel by channel, parameterizable
Alarms
• Diagnostic alarm
Yes; Parameterizable
Diagnostic messages
• Short-circuit
Yes; Outputs to M; encoder supply to M; module
by module
Diagnostics indication LED
• Channel status display
Yes; Green LED
• for module diagnostics
Yes; Green/red LED
• For load voltage monitoring
Yes; Green LED
Potential separation
between the load voltages
Yes
Potential separation channels
• between the channels, in groups of
8
• between the channels and backplane bus
Yes
• between the channels and the power sup-
ply of the electronics
No; 8 channels are non-isolated and 8 channels
are isolated from supply voltage 1L+
Isolation
Isolation tested with
707 V DC (type test)
Degree and class of protection
IP degree of protection
IP65/67
Ambient conditions
Ambient temperature during operation
• min.
-25 °C
• max.
55 °C
Connection method
Design of electrical connection for the inputs
and outputs
M12, 5-pole
Design of electrical connection for supply volt-
age
M8, 4-pole
ET-Connection
• ET-Connection
M8, 4-pin, shielded
Dimensions
Width
45 mm
Height
159 mm
Depth
40 mm
Weights
Weight, approx.
195 g