Reinstallation of the Software
8-10
SIMATIC Field PG Manual
A5E00075760-04
7. A selection of disk drives for the data transfer is next offered. The disk drive
selected is not the installation drive for Windows. It is the drive on which the
necessary installation files and extensions are saved. You need approximately
500 MB of additional memory for the Windows setup following the transfer.
During a standard installation Windows 2000 is installed on drive C:. Therefore,
please make sure when selecting a drive that there is enough available memory
on drive C: after the data transfer.
8. You can start the Windows setup after the data transfer and acknowledgment of
the completion message via the program
HD:\I386\WINNT.exe
(HD: drive on which the folder I368 was transferred to).
If a Windows operating system already installed, you can start the Windows
2000 setup after starting Windows via the program
HD:\I368\WINNT32.exe.
Choosing the Language for Windows 2000
The Multilanguage User Interface (MUI) allows you to set the Windows 2000
menus and dialogs to another language.
In order to install the MUI, run the program MUISETUP.EXE in the MUI folder on
the Recovery CD and follow the screen dialog to install the desired languages.
The desired language for Windows 2000 menus and dialogs, as well as the
keyboard layout can be set via the control panel with the dialog Start > Settings >
Control Panel > Regional Options > tab “General” > box “Menus and
dialogs” and in the tab “Inputs”, box “Keyboard layout” .
In addition to the language for menus and dialogs, you can also set via Regional
Options the standard for the region with Set Default.
Your device is set to English menus and dialogs and a US keyboard when
delivered. You can set another language and keyboard via the control panel with
the dialog Start >Settings > Control Panel > Regional Options > tab ”General”,
box ”Menus and dialogs”> tab ”Input locales”, box ”Input language”.
To Next Page
Loading...
Need help?
General
