Configuring the SIMATIC Field PG
5-3
SIMATIC Field PG Manual
A5E00075760-04
Screen Display Following Power On
With the standard setting of your PG, the screen displays after power-on, for
example:
PhoenixBIOS 4.0 Release 6.0 -A5E0001xxxx-ES00x
Copyright 1985-2000 Phoenix Technologies Ltd.
All Rights Reserved
SIEMENS Field PG
CPU = Intel(R) Mobile Pentium(R)III processor 700MHz
640K System RAM Passed
61M Extended RAM Passed
256K Cache SRAM Passed
System BIOS shadowed
Video BIOS shadowed
UMB upper limit segment address: xxxx
Mouse initialized
Fixed Disk 0: FUJITSU MHK2060AT
ATAPI Removable Drive: LS-120 S200 02 UHD Floppy
ATAPI CD-ROM: TOSHIBA CD-ROM XM-1902B
Press <F2> to enter SETUP
Notice
All information on on-screen displays and menu displays are samples. Deviations
to this example are possible.
Press the F2 key while the above display is shown, to select the ROM-based BIOS
setup program. In this program, you can set a number of system functions and
hardware configurations of your programming device.
The standard settings are effective on delivery. You can change these settings
using the BIOS setup. The modified settings become effective when you have
saved them and terminated the BIOS setup.
To Next Page
Loading...
Need help?
General
