Installing and connecting the device
3.1 Preparing for installation
IFP Basic
Operating Instructions, 03/2019, A5E46178354 - AB
19
6. Please inform the delivery service immediately if the package contents are incomplete or
damaged or do not correspond with your order.
Electric shock and fire hazard due to damaged device
A damaged device can be under hazardous voltage and trigger a fire in the machine or
plant. A damaged device has unpredictable properties and states.
Death or serious injury could occur.
Make sure that the damaged device is not inadvertently installed and put into operation.
Label the damaged device and keep it locked away. Send off the device for immediate
repair.
If the device is subjected to low temperatures or extreme fluctuations in temperature
during transportation, as is the case in cold weather, for example, moisture can build up
on or inside the device (condensation).
Moisture causes a short circuit in electrical circuits and damages the device.
In order to prevent damage to the device, proceed as follows:
• Store the device in a dry place.
• Bring the device to room temperature before starting it up.
• Do not expose the device to direct heat radiation from a heating device.
• If condensation develops, wait until the device is completely dry before switching it
on.
7. Keep the enclosed documentation in a safe place. You need the documentation when
you commission the device for the first time.
8. Write down the identification data of the device.
To Next Page
Loading...