Siemens SIMATIC IFP Basic Series

Installing and connecting the device
3.2 Installing the IFP Basic
IFP Basic
Operating Instructions, 03/2019, A5E46178354 - AB
25
3.2
Installing the IFP Basic
3.2.1
Notes on installation
Before installing the device, please ensure that the installation location complies with the
following:
WARNING
Risk of fire
The device is classified as "OPEN EQUIPMENT" for use in the area of industrial control
equipment in accordance with UL61010-2-201. In the event of overheating, the device may
discharge burning materials that can cause a fire.
Keep in mind:
• The installation of the device in an enclosure conforming to UL61010-2-201 is a
mandatory requirement for approval and operation in accordance with UL61010-2-201.
Note
If the equipment is used in an manner not specified by the manufacture, the protection
provided by the equipment might be impaired.
● Ensure that the protective contact socket of the building installation is easily accessible
and that there is a mains disconnect switch in switchgear cabinet installations.
● Position the device so that it is not exposed to direct sunlight.
● Position the device so that it is easily accessible for the operator.
● Choose a suitable installation height.
● Ensure that the air vents of the device are not covered as a result of installation. Note the
permitted mounting positions.