Siemens SIMATIC IFP Basic Series

Operating the device
5.4 Using the touch driver
IFP Basic
46 Operating Instructions, 03/2019, A5E46178354 - AB
Adjust constant touch area
To adjust the constant touch area, follow the below steps:
1. Click
Setting-->option
.
2. Select
Normal Mode
.
3. Select the radio button next to "Enable constant touch", and adjust the constant touch
area by clicking "Bigger" and "Smaller" or slide the slider.
Enable constant touch
To enable constant touch, set the mode as
Normal mode
in the setting page
.