Device maintenance and repair
7.4 Removing and installing hardware
SIMATIC IPC627D/827D
84 Operating Instructions, 09/2014, A5E32990859-AB
Removing and installing the power supply
Requirement
● The device is opened.
Remove the screw at the ind
i-
cated location below the on/off
switch on the back of the device.
Remove the identified screws
(Torx
T10) on the side.
slightly
and remove the identified power
supply connector from the power
supply unit.
Lift out the power supply unit completely.
Proceed in reverse order.
To Next Page
Loading...
Need help?
General
