Siemens SIMATIC MV550 S

SIMATIC MV500
Operating Instructions, 05/2019, C79000-G8976-C494-02
103
Process interfacing via an automation system (PLC,
PC)
9
You can operate the optical reader with either the WBM or an automation system. Using an
automation system (e.g. S7 controller), you can control the optical reader and view read
results and verification results.
Note
Controlling the readers via an automation system
Note that when the WBM is active, you can only control the readers via an automation
system (e.g. Saving and changing programs), if the "Take control" check box in the
"Security" tab is disabled for the current user in the "Options" menu
of the WBM.
Table 9- 1 Overview: Compatible communication modules, controllers and program blocks
Ident systems and MV
interface
Compatible program blocks in conjunction with ...
Ident profile
with S7-300/400/
1200/1500
FB 45
with S7-300/-400
1)
FB 79
with S7-300/-400
Without a dedicated
FB
SIMATIC MV500
(without CM)
PROFINET IO
✓
--
✓
✓
TCP/IP
--
--
--
✓
RS232 -- -- -- ✓
SIMATIC MV500
via ASM 456
✓ ✓ -- --
SIMATIC MV500
via ASM 475
-- ✓ -- --
SIMATIC MV500
via RF120C
✓
2)
-- -- --
SIMATIC MV500
via RF170C
✓ ✓ -- --
SIMATIC MV500
via RF180C
✓ ✓ -- --
SIMATIC MV500
via RF185C/RF186C/
RF188C
✓ ✓ -- --
SIMATIC MV500
via RFID 181EIP
-- -- -- ✓
3)
1)
Not recommended for designing new configurations.
2)
Only in conjunction with the S7-1200 controller
3)
An FB based on the Ident profile is available for connection via Rockwell controllers.