Commissioning
7.4 Connecting and setting up the reader using the PST
SIMATIC MV500
90 Operating Instructions, 05/2019, C79000-G8976-C494-02
Automatic adaption using the function "Full program"
As an alternative to the "READ" button, you can perform the adaption via the WBM using the
function "Full program" in the menu "Application > Program > Overview > Auto-setup".
However, the "Full program" function differs in the following points to the adaption using the
"READ" button:
● No "Align" LED is switched on, because alignment can be performed via the image
display of the WBM.
● The adaption progress is displayed in the "Auto-setup status" area.
● Once the adaption is completed, the reader automatically changes to edit mode ("Edit").
● Once the adaption is completed, the changes must be manually saved in the desired
target program.
You can find detailed information on this function in the "Application > Program > Overview >
Auto-Setup" section of the online help.
7.4 Connecting and setting up the reader using the PST
Requirements
● The reader has been connected to the power supply via the combination interface.
● The Primary Setup Tool is installed.
Table 7- 1 Steps for initial commissioning
Connect the optical reader and PC using an Ethernet cable.
2 Switch on the optical reader.
3 Select network adapter.
Configure the Ethernet connection between the optical reader and the PC.
4 Start Web Based Management (WBM).
Configure the optical reader using the WBM.
Step 1: Connect the reader and PC using an Ethernet cable
Connect the reader directly to your PC/programming device over an Ethernet cable.
Step 2: Switch on the optical reader
Disconnect the power supply of the optical reader. The optical reader is supplied with power
either via a connected CM cable or via the Power IO RS232 cable or PoE cable. You can
find more detailed information on the connection in the section "Connecting the power supply
(Page 77)".
To Next Page
Loading...
