Mounting
5.3 Mounting with built-in ring light and EF lens
SIMATIC MV500
68 Operating Instructions, 05/2019, C79000-G8976-C494-02
Mounting the individual components
Built-in ring light (including attachment)
M2.5 hexagon socket-head screws (3x)
Figure 5-4 Setup of SIMATIC MV540 optical reader with built-in ring light, EF lens and protective
lens barrel
Proceed as follows to mount the SIMATIC MV540 optical reader with built-in ring light, lens
and protective lens barrel:
1. Remove the protective foil from the reader.
2. Mount the ring light holder
②.
– Make sure that the ring light holder is aligned correctly and fully flush when it is
mounted. If needed, turn one of the hexagon socket screws back a little.
– Fasten the ring light holder
② with the three hexagon socket screws ④ onto the
reader (≤ 0.45 Nm).
3. Insert the straight connector of the lens cable into the interface of the reader (a).
4. Screw the desired lens
① into the lens mount of the reader ③.
Ensure the correct alignment of the lens so that the interface is close to the
cutout/interface (a). If needed, unscrew the lens slightly. If needed, align the lens using
the knurled nut/spring/counter ring.
5. Use the lens cable to connect the EF lens to the reader
③.
Insert the angled connector of the lens cable into the interface of the lens and the straight
connector into the interface of the camera. Ensure that the cable does not become
twisted.
6. Insert the micro SD adapter
⑤ into the reader interface provided.
If needed, insert a micro SD card into the adapter
7. Insert the connection board
⑥ into the reader interface provided.
To Next Page
Loading...
