Mounting
5.5 Mounting with external ring light
SIMATIC MV500
74 Operating Instructions, 05/2019, C79000-G8976-C494-02
5. Insert the micro SD adapter into the reader interface provided.
If needed, insert a micro SD card into the adapter
6. Screw the protective lens barrel (article number 6GF3540-8AC11) onto the reader.
7. Mount the ring light holder on the reader with the 4 screws (1-2 Nm) that are supplied.
8. Mount the external ring light to the ring light holder (1-2 Nm) with the 2 supplied fastening
screws.
9. Mount the reader on a suitable mounting fixture or holder (4x M4, 1-2 Nm).
Use the mounting plate for SIMATIC MV500 or a mounting device with matching holes.
Note that the reader has two different drilling templates (50 x 60/57 x 57).
10.Select a suitable location to install the device.
To Next Page
Loading...
