Siemens SIMATIC PANEL PC 877 - Page 123

Siemens SIMATIC PANEL PC 877

288 pages

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

Maintenance and service

12.4 Installing and removing hardware components

SIMATIC Panel PC 877

Operating instructions, Release 07/2006, A5E00877780-01

12-9

Open the device

Steps for opening the device

1 Remove the five screws (1).

2 Swing the lid to the front and

remove it.

Table of Contents

Default Chapter5
- Table of Contents5
- Operating Instructions, Release 07/200610
1 Foreword11
- Overview11
2 Safety Information13
- General Information16
3 Description19
- Design19
- Technical Features21
- Accessories23
4 Application Planning25
- Overview25
- Installation25
- Unpacking and Checking the Delivery26
- Device Identification Data27
- Mounting Positions and Fastening28
- Installation Guidelines28
- Permitted Mounting Positions30
- Type of Fixation31
- Protection against Dust and Water32
- Mounting Cut-Out33
- Preparing the Mounting Cut-Out33
- Table 4-1 Dimensions for the Mounting Cut-Out in MM34
- Mounting Depth of the Device35
- EMC Directive36
5 Installation37
- Securing the Device with Clamps37
- Securing the Device with Screws39
- Rack Installation40
6 Connecting43
- Connection and Operator Control Components43
- Connecting the 100 V to 240 V AC Power Supply46
- Connecting the 24 V DC Power Supply48
- Connecting the Equipotential Bonding Circuit49
7 Integration into an Automation System51
- Overview51
- Device in a SIMATIC S7 Configuration52
- MPI/PROFIBUS-DP Network52
- Connecting an S7 Automation System53
- Networking Via Industrial Ethernet54
8 Commissioning55
- Overview55
- Switch on the Device56
- Setting up the Microsoft Windows Operating System57
- Installing Applications and Drivers58
  - Operation and Configuration61
  - Functions61
- BIOS Settings63
- Microsoft Windows Operating System64
- Enables64
- Windows 2000 Professional65
- Windows XP Professional66
- Usb67
9 Operation and Configuration69
- Normal Operation69
- Switch on the Device69
- Logging on to the Operating System Via the Onscreen Keyboard (OSK)71
- Switching off the Device72
- Additional Drivers and Applications73
- Overview73
- Calibrating the Touch Screen, UPDD74
- Enable/Disable Touch Functionality76
- Windows Security Center (Windows XP Professional Only)78
- Keytools (for Key Panel Devices Only)80
- Screen Keyboard (for Touch Panel Device Only)81
- Setbrightness82
- Checklanguageid83
- Multilingual Settings for the Operating System84
- DVD Rom/CD Rw86
- USB Keyboard Controller87
10 Operation89
- Status Displays89
- General Control Elements90
- Device with Key Panel91
- Using the Keyboard92
- Control Keys93
- Using the Direct Control Key Module98
- Labelling Function Keys and Softkeys102
- Using the Integrated Mouse104
- Device with Touch Screen105
- Using the Touch Screen106
- Disk Drive107
- Transferring Authorizations108
11 Functions109
- Overview109
- Safecard on Motherboard (SOM)110
- Temperature Monitoring112
- Watchdog (WD)113
- Fan Monitoring114
12 Maintenance and Service115
- Servicing115
- Replacement Parts117
- Separating the Control Unit from the Computer Unit118
- Installing and Removing Hardware Components121
- Repairs121
- Open the Device122
- Installing and Removing Memory Modules124
- Installing PCI / at Cards126
- Notes on the Modules126
- Installing / Removing Expansion Modules127
- Exchanging the RAID Controller PCI Card129
- Disk Drives130
- Options of Installing Disk Drives130
- Installing / Removing a Drive Bay132
- Removing and Installing an Optical Drive135
- Removing and Installing a 3.5" Hard Disk138
- Replacing the Backup Battery139
- Removing/Installing the Power Supply141
- Installing Software143
- General Installation Procedure143
- Setting up the Partitions for Windows Operating Systems144
- Compatibility of the Restore DVD146
- Restoring the Factory State of the Software Using the Restore DVD147
- Installing Microsoft Windows Operating Systems149
- Operating System Not Installed149
- Booting from the Recovery CD150
- Installing the Microsoft Windows Operating System (Not for RAID)151
- Installing the Microsoft Windows Operating System (for RAID)152
- Installing Individual Drivers153
- Operation of Two Hard Disks154
- HDD System154
- RAID System with Promise Fast Track Controller TX2300155
- Installing the RAID Controller Software158
- Installing Burner and DVD Software159
- Backing up the Hard Disk160
13 Alarm, Error and System Messages161
- Boot Error Messages161
- Introduction to the BIOS Beep Codes163
- Table 13-1 Converting the Beep Codes in a Hex Display163
- BIOS Beep Codes165
14 Troubleshooting/Faqs167
- General Problems167
- Problems When Using Modules of Third-Party Manufacturers168
- Technical Data169
- Temperature Limits169
15 Technical Data171
- General Technical Data171
- Power Requirements of the Components178
- Device with AC Voltage Supply179
- Device with DC Voltage Supply180
- Keyboard Table181
16 Dimension Drawings189
- Panel PC 877 Dimensional Drawing189
- Dimensional Drawings for the Installation of Expansion Modules191
17 Detailed Descriptions193
- Motherboard193
- Structure and Functions of the Motherboard193
- Technical Features of the Motherboard194
- Position of the Ports on the Motherboard196
- External Interfaces197
- Front Interfaces205
- Internal Interfaces210
- Bus Board216
- Layout and Principle of Operation216
- Assignment of the PCI IRQ Channels to the PCI Slots217
- Exclusive PCI Hardware Interrupt218
- ISA Slot Pin Assignment219
- Operating System Licenses221
- Cables222
- System Resources223
- Currently Allocated System Resources223
- System Resources Used by the BIOS/DOS224
- I/O Address Allocation224
- Interrupt Assignments226
- Memory Address Assignments227
- BIOS Setup228
- Overview228
- Starting BIOS Setup229
- BIOS Setup Menus230
- Main Menu232
- Advanced Menu243
- Security Menu251
- Power Menu253
- Boot Menu254
- Version Menu256
- Exit Menu257
- BIOS Setup Default Settings258
Appendix261
- Guidelines and Declarations261
  - A.1 Certificates and Guidelines261
  - A.1.1 Guidelines and Declarations261
- A.1 Certificates and Guidelines262
- Certificates and Approvals263
- Electrostatic Charging of Individuals265
- Additional Support266
- A.2 Additional Support266
- BESD Directives268
  - ESD Guideline268
- List of Abbreviations / Acronyms269
- C.1 Abbreviations269
100 C List of Abbreviations / Acronyms270
- C.1 Abbreviations270
- Glossary271
- Index281

Related product manuals

Siemens SIMATIC Box PC 820

Preview: Siemens Simatic box pc 627b

Siemens Simatic box pc 627b

Preview: Siemens SIMATIC Rack PC 840

Siemens SIMATIC Rack PC 840

Preview: Siemens SIMATIC Rack PC 840 V2

Siemens SIMATIC Rack PC 840 V2

Preview: Siemens SIMATIC PCS 7 BOX

Siemens SIMATIC PCS 7 BOX

Preview: Siemens SIMATIC IPC PX-39A

Siemens SIMATIC IPC PX-39A

Siemens SIMATIC Field PG M4

Siemens SIMATIC IPC PX-39A PRO

Preview: Siemens Simatic series

Siemens Simatic series

Preview: Siemens SIMATIC IPC547D

Siemens SIMATIC IPC547D

Preview: Siemens Simatic IPC527G

Siemens Simatic IPC527G

Preview: Siemens SIMATIC IPC427E

Siemens SIMATIC IPC427E