Step Action
5
● Find the row in the table with the following entries:
Chart column; "MOTOR1" entry and Block column; "FbkRun" entry
● Open in the corresponding "Signal" column from the shortcut menu. Select the
Insert Signal menu command.
● In the "Insert Signal" dialog box, open the shortcut menu of the "Inputs" folder in the right
window and select Open.
The "Insert Signal" dialog box opens.
● Open the "SIMATIC 400 ...\Outputs" folder.
● Select the "MOTOR1-OUT" signal in the right window and click "Apply".
The signal is inserted.
6 The following table shows the signals that you have to assign to the block I/Os. Proceed as
described in the previous step.
Note that you must switch between the "Inputs" and "Outputs" folders in the left window of
the "Insert Signal" dialog box for each signal.
7 Close the "Insert Signal" dialog box.
Programming and interconnecting the process tags
7.1 How to program and interconnect the process tags
Getting Started (V8.1 with APL)
48 Getting Started, 07/2014, A5E32713210-AA
To Next Page
Loading...
