Siemens SIMATIC S5 - Calling up Program Sections

Program outputting
Call function selection menu with m
Select PU-function
Gutputting in
LAD
Gutputting in STL
Display:
Start of program if a program is stored
in the PU-memory.
EM is displayed in the input field,
if the PU-memory has been cleared.
Calling up program section
A requ~red section or point of a
program
(e.g. Network 5 or statement 70)
may be called up by first selecting
"PROG. LAD" or "PROG. STL" and then by
using the positioning keys (see page
8).
Alternatively, a search run may be
employed.