Siemens Simatic S7-1500 / ET 200MP - Digital Input Electrical Characteristics; Digital Output Electrical Characteristics

Technical specifications
Technology module TM FAST (6ES7554-1AA00-0AB0)
52 Equipment Manual, 04/2023, A5E52301130-AA
Article number
6ES7554-1AA00-0AB0
SIMATIC S7-1500, TM FAST Field Adaptable
High-Speed Technology, programmable with
Intel(R) Quartus(R) Prime software, 8xDI, 8xDQ,
4xDIQ 24 V, 8xRS485 DIQ, for extremely short
response time of less than 1 µs
Digital inputs
Number of digital inputs
12; including 4 DIQs
Digital inputs, parameterizable
Yes
Input characteristic curve in accordance with IEC 61131, type 3
Yes
Input voltage
•
Type of input voltage
DC
•
Rated value (DC)
24 V
•
for signal "0"
-5 ... +5 V
•
for signal "1"
+11 to +30V
• permissible voltage at input, min.
-5 V; -5 V continuous, -30 V brief reverse polari-
ty protection
•
permissible voltage at input, max.
30 V
Input current
•
for signal "1", typ.
2.5 mA
Input delay (for rated value of input voltage)
• Minimum pulse width for program reactions
application specific below 1µs possible
for standard inputs
– parameterizable
Yes; customer defined / 0.001 / 0.003 / 0.05 /
0.1 / 0.4 / 0.8 / 1.6 / 3.2 / 12.8 / 20 ms
– at "0" to "1", min.
0.8 µs; for parameterization "customer defined
= 0"
–
at "1" to "0", min.
0.8 µs; for parameterization "none"
Cable length
•
shielded, max.
100 m
Digital outputs
Number of digital outputs
12; including 4 DIQs
Current-sinking
Yes; 8 push-pull outputs
Current-sourcing
Yes
Short-circuit protection
Yes; electronic/thermal
• Response threshold, typ.
0.2 A
Switching capacity of the outputs
•
with resistive load, max.
0.1 A; 0.3 A for DIQs
Load resistance range
• lower limit
240 Ω; 80 ohms for DIQs
• upper limit
12 kΩ