Siemens Simatic S7-1500 / ET 200MP - Page 54

Technical specifications
Technology module TM FAST (6ES7554-1AA00-0AB0)
Equipment Manual, 04/2023, A5E52301130-AA
53
Article number
6ES7554-1AA00-0AB0
SIMATIC S7-1500, TM FAST Field Adaptable
High-Speed Technology, programmable with
Intel(R) Quartus(R) Prime software, 8xDI, 8xDQ,
4xDIQ 24 V, 8xRS485 DIQ, for extremely short
response time of less than 1 µs
Output voltage
• Type of output voltage
DC
• for signal "1", min.
23.2 V; L+ (-0.8 V), L+ (-1.3 V) for DIQs
Output current
• for signal "1" rated value
0.1 A; 0.3 A for DIQs
• for signal "1" permissible range, max.
0.12 A; 0.36 A for DIQs
• for signal "1" minimum load current
2 mA
• for signal "0" residual current, max.
0.5 mA
Output delay with resistive load
•
"0" to "1", typ.
420 ns
•
"1" to "0", typ.
420 ns
Switching frequency
• with resistive load, max.
200 kHz; 1 kHz for DIQs
• For signal interface 24 V asymmetrical
200 kHz; 1 kHz for DIQs
• For signal interface RS 422 symmetrical
2 MHz
• For signal interface TTL (5 V) asymmetrical
200 kHz
Cable length
• shielded, max.
30 m
Encoder
Interface types
•
TTL 5 V
Yes; 8 channels (direction switchable)
•
RS 422
Yes; 8 channels (direction switchable)
•
Source/sink input
Yes
•
Input characteristic curve in accordance with IEC 61131, type 3
Yes
Isochronous mode
Bus cycle time (TDP), min.
250 µs
Interrupts/diagnostics/status information
Diagnostics function
Yes
Substitute values connectable
Yes
Alarms
• Diagnostic alarm
Yes