Siemens Simatic S7-400 - Page 167

03/2013 3 Setting up functions
3.4 Fault services
© Siemens AG 2006-2013 All Rights Reserved
SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013
3-167
Function Description Type
The next interval only starts once the trigger has
been successfully triggered.
Weekly Enter a cycle 'n' in
- Weeks,
by selecting a day of the week from Monday to
Sunday
DISPLAY
INPUT
SELECTION
(1 to 99 999
minutes or
hours)
Monthly Enter a cycle 'n' in
- Months.
Either by selecting the
- first
- second
- third
- fourth
day of the week from Monday to Sunday in the
month
- OR -
one day from 1 to 31 in the month (then, without
a weekday).
DISPLAY
INPUT
SELECTION
(1 to 99 999
minutes or
hours)
Duration of the interval
There is no restriction pre-selected regarding a
last initiation.
If you deselect undefined, you need to select a
date for the last execution.
DISPLAY
SELECTION
(Toggle)
Last execution
Undetermined
On the
You can only make an entry if undefined is
deselected for the last execution.
The can only specify a date for the last
execution via the calendar selection function.
See above: Calendar field
DISPLAY
SELECTION
Each trigger can be assigned a label, which determines its behavior at the central
start date for maintenance.
See also Section: Editing the master data of a machine and the general description
of the trigger in Section: Setting up functions.